ulimit:
Used to set user limits of system-wide resources. Provides control over resources available to the shell and processes started by it. Some common ulimit commands may include:
Disabling Linux services:
Certain Linux services may be disabled to minimize tasks that may consume CPU cycles.
irqbalance:
Disabled through "service irqbalance stop". Depending on the workload involved, the irqbalance service reassigns various IRQ's to system CPUs. Though this service might help in some situations, disabling it can also help environments which need to minimize or eliminate latency to more quickly respond to events.
Performance Governors (Linux):
In-kernel CPU frequency governors are pre-configured power schemes for the CPU. The CPUfreq governors use P-states to change frequencies and lower power consumption. The dynamic governors can switch between CPU frequencies, based on CPU utilization to allow for power savings while not sacrificing performance.
Other options beside a generic performance governor can be set, such as the perf-bias:
--perf-bias, -b
On supported Intel processors, this option sets a register which allows the cpupower utility (or other software/firmware) to set a policy that controls the relative importance of performance versus energy savings to the processor. The range of valid numbers is 0-15, where 0 is maximum performance and 15 is maximum energy efficiency.
The processor uses this information in model-specific ways when it must select trade-offs between performance and energy efficiency. This policy hint does not supersede Processor Performance states (P-states) or CPU Idle power states (C-states), but allows software to have influence where it would otherwise be unable to express a preference.
On many Linux systems one can set the perf-bias for all CPUs through the cpupower utility with one of the following commands:
Tuning Kernel parameters:
The following Linux Kernel parameters were tuned to better optimize performance of some areas of the system:
tuned-adm:
The tuned-adm tool is a commandline interface for switching between different tuning profiles available to the tuned tuning daeomn available in supported Linux distros. The default configuration file is located in /etc/tuned.conf and the supported profiles can be found in /etc/tune-profiles.
Some profiles that may be available by default include: default, desktop-powersave, server-powersave, laptop-ac-powersave, laptop-battery-powersave, spindown-disk, throughput-performance, latency-performance, enterprise-storage
To set a profile, one can issue the command "tuned-adm profile (profile_name)". Here are details about relevant profiles.
Transparent Huge Pages (THP):
THP is an abstraction layer that automates most aspects of creating, managing, and using huge pages. THP is designed to hide much of the complexity in using huge pages from system administrators and developers, as normal huge pages must be assigned at boot time, can be difficult to manage manually, and often require significant changes to code in order to be used effectively. Transparent Hugepages increase the memory page size from 4 kilobytes to 2 megabytes. Transparent Hugepages provide significant performance advantages on systems with highly contended resources and large memory workloads. If memory utilization is too high or memory is badly fragmented which prevents hugepages being allocated, the kernel will assign smaller 4k pages instead. Most recent Linux OS releases have THP enabled by default.
Linux Huge Page settings:
If you need finer control and manually set the Huge Pages you can follow the below steps:
Note that further information about huge pages may be found in your Linux documentation file: /usr/src/linux/Documentation/vm/hugetlbpage.txt
]]>Model | Nominal TDP | Minimum cTDP | Maximum cTDP** |
---|---|---|---|
EPYC 7742 | 225 | 225 | 240 |
EPYC 7702 | 200 | 165 | 200 |
Last updated Oct. 29, 2019.
]]>