# Invocation command line: # /cpu2006/bin/runspec -c cpu2006.1.0.SLES10x64.ic91.em64t.Mar272007 -T all --input ref -n 3 --rate 16 -o all int # output_root was not used for this run ############################################################################ ###################################################### # SPEC CPU2006 Intel SLES10 x64 (64-bit) config file # # Mar 27 2007 Intel Compiler 9.1 for Linux Intel64 # ###################################################### action = validate tune = base or peak ext = cpu2006.1.0.SLES10x64.ic91.em64t.Mar272007 PATHSEP = / flagsurl000 = http://www.spec.org/cpu2006/flags/CPU2006_flags.20090714.09.xml check_md5 = 1 mean_anyway = 1 reportable = 1 #include: SUT.inc # ----- Begin inclusion of 'SUT.inc' ############################################################################ # File to be included into config file for SPEC CPU2006 # This include file specifies the "System Under Test" (Hardware, # OS, BIOS, etc.) # Any information about the binaries is elsewhere. # To avoid conflicts in the numbering of the notes, # please use only 900 and higher numbers. ####################################################################### # System information # # If some remarks about BIOS or Firmware are needed, place them here. # ####################################################################### default=default=default=default: notes_os_000= 'ulimit -s unlimited' was used to set the stacksize to unlimited prior to run notes_os_005= '/usr/bin/taskset' used to bind processes to CPUs notes_000= notes_005= The system bus runs at 800 MHz notes_010= notes_030= notes_035= BIOS configuration: notes_040= Hardware Prefetch = Enable # notes909= Adjacent Sector Prefetch = Enable int=default=default=default: notes_015= All binaries were built with 32-bit Intel compiler except: notes_020= 401.bzip2, 456.hmmer and 462.libquantum in peak were built with notes_025= 64-bit Intel compiler by changing the path for include and library files. fp=default=default=default: notes903= All binaries were built with 64-bit Intel compiler except: notes904= 433.milc, 434.zeusmp, 450.soplex, 470.lbm and 482.sphinx3 in peak were built with notes905= 32-bit Intel compiler by changing the path for include and library files. ################################### # About Fujitsu Siemens Computers # ################################### default=default=default=default: notes_045= notes_050= This result was measured on the PRIMERGY RX600 S3. The PRIMERGY RX600 S3 and notes_055= the PRIMERGY TX600 S3 are electronically equivalent. notes_060 = notes_065 = For information about Fujitsu Siemens Computers in your country please see: notes_070 = http://www.fujitsu-siemens.com/countries ##################################### # Description Hardware and Software # ##################################### default=default=default=default: hw_vendor = Fujitsu Siemens Computers hw_model000 = PRIMERGY TX600 S3, Intel Xeon processor 7130M, hw_model001 = 3.20 GHz hw_cpu_name = Intel Xeon 7130M hw_cpu_char = 800 MHz system bus hw_cpu_mhz = 3200 hw_fpu = Integrated # hw_nchips = 4 hw_ncores = 8 hw_ncoresperchip = 2 hw_nthreadspercore = 2 # hw_ncpuorder = 1,2,4 chips hw_pcache = 12 K micro-ops I + 16 KB D on chip per core hw_scache = 1 MB I+D on chip per core hw_tcache = 8 MB I+D on chip per chip hw_ocache = None hw_memory000 = 32 GB (16x2 GB DDR2 PC2-3200R, 2 rank, CAS 3-3-3, hw_memory001 = with ECC) hw_disk = Seagate ST973401SS (SAS 73GB 10 krpm) hw_other = None sw_file = ReiserFS sw_state = Multiuser Runlevel 3 license_num = 22 test_sponsor = Fujitsu Siemens Computers tester = Fujitsu Siemens Computers test_date = May-2007 hw_avail = Aug-2006 prepared_by = Fujitsu Siemens Computers config = cpu2006.1.0.SLES10x64.ic91.em64t.Mar272007.cfg # ---- End inclusion of '/cpu2006/config/SUT.inc' default=default=default=default: CC = icc CXX = icpc FC = ifort OBJ = .o SMARTHEAP_DIR = /opt/SmartHeap_8_1/lib submit= MYMASK=`printf '0x%x' \$((1<<\$SPECCOPYNUM))`; /usr/bin/taskset \$MYMASK $command ########################### # portability & libraries # ########################### fp=default=default=default: PORTABILITY = -DSPEC_CPU_LP64 400.perlbench=default=default=default: CPORTABILITY = -DSPEC_CPU_LINUX_X64 462.libquantum=default=default=default: CPORTABILITY = -DSPEC_CPU_LINUX 483.xalancbmk=default=default=default: CXXPORTABILITY = -DSPEC_CPU_LINUX 435.gromacs=default=default=default: LDPORTABILITY = -nofor_main 436.cactusADM=default=default=default: LDPORTABILITY = -nofor_main 454.calculix=default=default=default: LDPORTABILITY = -nofor_main 481.wrf=default=default=default: CPORTABILITY = -DSPEC_CPU_CASE_FLAG -DSPEC_CPU_LINUX ######################### # Baseline Tuning Flags # ######################### int=base=default=default: COPTIMIZE= -fast CXXOPTIMIZE= -xP -O3 -ipo -no-prec-div EXTRA_CXXLIBS= -L$(SMARTHEAP_DIR) -lsmartheap fp=base=default=default: OPTIMIZE= -fast ##################### # Peak Tuning Flags # ##################### int=peak=default=default: OPTIMIZE= -fast EXTRA_LIBS= -L$(SMARTHEAP_DIR) -lsmartheap PASS1_CFLAGS = -prof_gen PASS2_CFLAGS = -prof_use PASS1_CXXFLAGS = -prof_gen PASS2_CXXFLAGS = -prof_use PASS1_LDFLAGS = -prof_gen PASS2_LDFLAGS = -prof_use fp=peak=default=default: OPTIMIZE= -fast PASS1_CFLAGS = -prof_gen PASS2_CFLAGS = -prof_use PASS1_FFLAGS = -prof_gen PASS2_FFLAGS = -prof_use PASS1_CXXFLAGS = -prof_gen PASS2_CXXFLAGS = -prof_use PASS1_LDFLAGS = -prof_gen PASS2_LDFLAGS = -prof_use 400.perlbench=peak=default=default: EXTRA_LIBS= 401.bzip2=peak=default=default: CC=/opt/intel/cce/9.1.047/bin/icc -I/opt/intel/cce/9.1.047/include -L/opt/intel/cce/9.1.047/lib PORTABILITY=-DSPEC_CPU_LP64 EXTRA_LIBS= feedback=0 403.gcc=peak=default=default: basepeak=yes 456.hmmer=peak=default=default: CC=/opt/intel/cce/9.1.047/bin/icc -I/opt/intel/cce/9.1.047/include -L/opt/intel/cce/9.1.047/lib PORTABILITY=-DSPEC_CPU_LP64 EXTRA_LIBS= 462.libquantum=peak=default=default: CC=/opt/intel/cce/9.1.047/bin/icc -I/opt/intel/cce/9.1.047/include -L/opt/intel/cce/9.1.047/lib PORTABILITY=-DSPEC_CPU_LP64 EXTRA_LIBS= 471.omnetpp=peak=default=default: OPTIMIZE=-xP -O3 -ipo -no-prec-div 483.xalancbmk=peak=default=default: basepeak=yes 410.bwaves=peak=default=default: basepeak=yes 416.gamess=peak=default=default: basepeak=yes 433.milc=peak=default=default: PORTABILITY= CC=/opt/intel/cc/9.1.047/bin/icc -I/opt/intel/cc/9.1.047/include -L/opt/intel/cc/9.1.047/lib 434.zeusmp=peak=default=default: PORTABILITY= FC=/opt/intel/fc/9.1.043/bin/ifort -I/opt/intel/fc/9.1.043/include -L/opt/intel/fc/9.1.043/lib feedback=0 436.cactusADM=peak=default=default: basepeak=yes 437.leslie3d=peak=default=default: basepeak=yes 444.namd=peak=default=default: basepeak=yes 450.soplex=peak=default=default: PORTABILITY= CXX=/opt/intel/cc/9.1.047/bin/icpc -I/opt/intel/cc/9.1.047/include -L/opt/intel/cc/9.1.047/lib 459.GemsFDTD=peak=default=default: basepeak=yes 470.lbm=peak=default=default: PORTABILITY= CC=/opt/intel/cc/9.1.047/bin/icc -I/opt/intel/cc/9.1.047/include -L/opt/intel/cc/9.1.047/lib 481.wrf=peak=default=default: basepeak=yes 482.sphinx3=peak=default=default: PORTABILITY= CC=/opt/intel/cc/9.1.047/bin/icc -I/opt/intel/cc/9.1.047/include -L/opt/intel/cc/9.1.047/lib feedback=0 ######################### # Used Compilers and OS # ######################### int=default=default=default: sw_compiler000 = Intel C++ Compiler for IA32/EM64T application, sw_compiler001 = Version 9.1 - Build 20070215, Package-ID: sw_compiler002 = l_cc_p_9.1.047 sw_other = Smart Heap Library, Version 8.1 sw_base_ptrsize = 32-bit sw_peak_ptrsize = 32/64-bit fp=default=default=default: sw_compiler001 = Intel C++ Compiler for IA32/EM64T application, sw_compiler002 = Version 9.1 - Build 20070215, Package-ID: l_cc_p_9.1.047 sw_compiler003 = Intel Fortran Compiler for IA32/EM64T application, sw_compiler004 = Version 9.1 - Build 20070215, Package ID: l_fc_p_9.1.043 sw_other = None sw_base_ptrsize = 64-bit sw_peak_ptrsize = 32/64-bit default=default=default=default: sw_os000 = 64-Bit SUSE LINUX Enterprise Server 10, Kernel sw_os001 = 2.6.16.21-0.8-smp on an x86_64 sw_avail = Mar-2007 sw_auto_parallel = No ###################### # End of config-file # ######################